Carbide circular saw blade for sandwich panels 216 × 2.8/1.8 × 30 mm – 62 teeth – TCG negative

Carbide circular saw blade for sandwich panels 216 × 2.8/1.8 × 30 mm – 62 teeth – TCG negative

Dry cutting of faced composite panels. Sandwich panels | Façade profiles | Thin sheet up to 2 mm.

Technical data

• Dimensions Ø × kerf/plate × bore: 216 × 2.8/1.8 × 30 mm
• Number of teeth: 62
• Tooth form: TCG negative
• Quality: HM
• Hook angle: negative
• Materials: Sandwich panels | Façade profiles | Thin sheet up to 2 mm
• Application: Dry cutting of faced composite panels
• Machine use: Suitable low-speed hand-held, mitre or dry-cut saw
• Speed note: Only an expressly suitable low-speed machine; observe maximum speed

Price on request

Product safety

• Use only as intended in a suitable circular saw and for the specified materials. Blade diameter, bore, kerf, plate thickness, clamping flange, rotation direction and permitted speed must match the machine.
• Before every use, inspect the plate, bore, clamping faces, expansion slots and teeth for cracks, distortion, corrosion, missing tips or other damage. Do not use damaged, blunt or improperly resharpened blades.
• Switch off the machine before fitting, cleaning, adjustment or inspection, disconnect the power supply, secure against restart and wait for a complete stop.
• Clean the spindle, flanges and clamping faces. Fit the blade fully in the correct rotation direction without play in reducing rings; use only matching, undamaged flanges and approved reducing rings.
• Set the guard, riving knife and other protective devices according to the machine instructions. Never operate without effective guards or with an unsuitable riving knife.
• Fully support and securely guide or clamp the workpiece. Do not cut freehand; keep hands out of the cutting line and kickback zone. Feed evenly against the intended cutting direction.
• Wear safety glasses or a face shield and hearing protection; use suitable extraction. Do not wear gloves, loose clothing or jewellery, and secure long hair near rotating parts.
• Do not side-load, jam or brake the blade or place it on stationary workpieces. Do not set down or open the machine until the blade has stopped completely.
• Teeth, cut edges, workpieces and chips may be sharp and hot. Allow them to cool, store the blade protected and secure it against impact and contact during transport.
• Support sandwich panels across their surface and secure both facings against movement. Beware of sharp sheet edges and hot chips.
• Use only on expressly suitable low-speed machines. Dry cutting without coolant only as specified by product and machine markings; high tooth count increases kickback and torque demands.
• Traceability is provided by article number TP_KSB-100230 and any batch marking on the label or packaging.

Manufacturer and EU responsible person

ToolParts-Group
Manufacturer and EU responsible economic operator
Kleinhaslach 35
90599 Dietenhofen
Germany
E-Mail: info@toolparts-service.biz
Tel.: +49 175 9967647
https://www.toolparts-group.com/